24/7 Emergency Response No Call-Out Fee Over 2 Hours Gas Safe Registered
[email protected]
✓Trusted Plumber London020 7870 3200
24/7 Emergency · No find, no fee · Main leak detection £595 fixed

Water Leak Repair London

Visible pipe leaks, hidden leaks behind walls, burst pipes, leaking joints — we locate and repair all water leaks across London. 24/7 emergency response, acoustic leak detection, no find no fee.

📞 Call 020 7870 3200Book Online →

🚨 Active Leak Right Now? Do This First:

  1. Turn off the water at the main stopcock — usually under the kitchen sink or at the property entry point
  2. Switch off electricity at the consumer unit if water is near lights, sockets, or the boiler
  3. Contain the water with towels and buckets to prevent floor and ceiling damage
  4. Call us now — we respond 24/7 (emergency leak call-out £70, someone with you within 1 hour): 020 7870 3200

Types of Water Leak We Repair

From a dripping joint under your kitchen sink to a pressurised burst pipe in a ceiling void, we handle every leak scenario across London's diverse housing stock — Victorian terraces, Edwardian semis, 1960s council blocks, and modern new-builds.

🔩

Leaking Joints & Fittings

Compression joints, push-fit fittings, and solder joints can fail over time — especially in older London properties where copper has corroded or joints were poorly made. Quick repair without pipe replacement.

£95 per hour

📍

Pinhole Leaks

London's hard, slightly acidic water attacks the inside of copper pipes over decades. Pinhole leaks appear as a spray or drip from the pipe body itself. Requires a pipe section replacement rather than just fitting repair.

£95 per hour

🌊

Burst Pipe (Emergency)

Sudden, high-volume leak from a split pipe — caused by frost, pressure surge, or corrosion failure. Turn off the stopcock immediately. We respond 24/7 with emergency repair kits and replacement pipework.

£95 per hour

🔍

Hidden / Concealed Leaks

Leaks inside walls, under floors, or in ceiling voids. Detected with acoustic equipment and thermal cameras. We locate the exact point before cutting, minimising damage to your finishes.

Detection £180 per hour

🏠

Under-Floor Leaks

Underfloor heating pipes or supply pipes beneath screed or floorboards. We pressure-test to isolate the zone, then use acoustic detection to pinpoint — avoiding full floor excavation wherever possible.

Detection £180 per hour

🚿

Leaking Shower / Bath Waste

Silicone seal failure, cracked waste fitting, or loose trap connection. Water tracks through the floor into the ceiling below. Resealing or waste replacement before structural damage occurs.

£95 per hour

Yellow tracer gas detector showing a high hydrogen reading while resting on a patterned rug
From a recent Trusted Plumber London job.

Signs You Have a Hidden Water Leak

Hidden leaks are the most damaging — by the time you notice, water may have been tracking through your structure for weeks. In London's dense housing stock, a leak in a flat above will always find someone's ceiling below.

SignWhat to check
Water meter moves with all taps offIsolate your supply and watch the meter dial for 30 minutes
Unexplained damp patches on walls/ceilingsEspecially if they grow over time or appear after rain-free days
Wallpaper bubbling or paint peelingMoisture tracked through from a leak behind the surface
Musty/damp smell in a roomMould growing behind walls due to sustained moisture
Hot spots on a cold floorUnderfloor heating pipe leak — warmth spreads around the breach
Unusually high water billEven a small hidden leak can waste hundreds of litres per day

Is It a Leak? Run This Meter Test First

A water meter shows a hidden leak before the damp does. The test takes a few minutes of your time and an hour or two of waiting.

  1. Turn off every tap and appliance. Check that no cistern is refilling.
  2. Read the meter, or take a photo of it.
  3. Wait an hour or two. For a slow leak, leave it overnight.
  4. Read it again. If the reading has moved, or the low-flow indicator is still turning, water is escaping.

Check the toilets before you blame a buried pipe. A cistern that leaks into the pan is a common cause. Add a few drops of food colouring to the cistern and do not flush. If colour shows in the pan after about 30 minutes, the leak is the cistern.

Other signs are a drop in water pressure, a hiss from a wall when everything is off, and a bill that rises with no change in how you use water. If a sealed heating system keeps losing pressure and needs topping up, the leak may be in the heating pipework and not the water supply.

How We Find Hidden Leaks — Without Destroying Your Home

We use specialist equipment to locate leaks before touching a single wall. Most hidden leaks can be pinpointed to within 30cm — minimising access damage.

1

Pressure Test

Isolate sections of pipework and monitor pressure drop to confirm a leak exists and roughly where.

2

Acoustic Listening

Electronic ground microphones pick up the distinctive hiss of pressurised water escaping through a breach.

3

Thermal Imaging

Thermal camera identifies temperature anomalies — wet areas behind walls and under floors show as cool zones.

4

Targeted Access

Once confirmed, we make the smallest possible opening to access and repair the leak, then restore the surface.

What Each Detection Method Can and Cannot Do

A surveyor rarely relies on one method. The choice depends on the pipe material, how deep it runs and what covers it.

Pressure test

Confirms whether a section of pipework is losing pressure. It proves a leak exists but does not say where.

Acoustic listening

Picks up the noise of water escaping a pressurised pipe. It works well on metal pipes. Plastic pipes carry sound poorly, and background noise can mask the signal.

Thermal imaging

Shows surface temperature, so a hot pipe leak or a damp area can stand out. It sees the surface only, and thick screed or concrete can hide a leak.

Moisture meter

Maps how far damp has spread. It shows where the damage is, not where the pipe has failed.

Tracer gas

A harmless mix of hydrogen and nitrogen is put in an emptied pipe. It escapes at the leak, rises through the floor and is picked up at the surface. It is used when other methods cannot pinpoint the leak, and the pipe must be taken out of use.

Drain camera and dye test

For waste pipework. A camera shows cracks, displaced joints and roots. Dye shows where water is going.

What a Leak Survey Report Includes

You get the findings in writing. The report states the symptoms you reported, the tests carried out and what each showed. It says whether the leak is on the water supply, the heating or the waste pipework. It gives the location, measured from fixed points such as walls and door frames, with photographs and any thermal images or moisture readings. It also gives the likely cause and the repair we recommend.

Many insurers ask for this kind of evidence on an escape-of-water claim. What a policy pays for varies, and some cover tracing and access while others do not. Check with your insurer before the survey and keep the report and photographs for your claim.

How We Price Leak Detection and Repair

Main water leak detection is a fixed £595. A comprehensive investigation is £660. It checks the whole property for all types of leaks, excluding roofs, and includes tracer gas, moisture mapping, pressure testing and so on. Detection by the hour is £180 per hour with the tracer gas bottle included. It is no find, no fee.

Leak jobs scheduled in advance have no call-out fee. An emergency leak call-out, right now, is £70, and we guarantee someone will be there within one hour.

Repair work is £95 per hour. We confirm the price in writing before we repair anything or open up a floor or wall. You decide whether to go ahead.

Leak Detection and Water Leak Repair Prices, London 2026

ServiceDetailsPrice
Main water leak detectionFixed price£595
Comprehensive leak detection investigation (whole property, excluding roofs)Tracer gas, moisture mapping, pressure testing and so on£660
Leak detection by the hourTracer gas bottle included£180 per hour
Emergency leak call-out, right nowSomeone with you within 1 hour£70
Leak jobs scheduled in advanceBooked aheadNo call-out fee
Plumbing repair work (not detection)Depends on the job£95 per hour

No find, no fee on leak detection. Some companies charge a separate fee for the gas bottle. Ours is included. Repair work is £95 per hour and we confirm the price in writing before we start. The £60 call-out, waived over 2 hours, applies to ordinary plumbing, not to leak detection. Parts are quoted before they are ordered. Insurance reports available on request.

Emergency Leak Response Across London

Engineers available 24 hours, 7 days a week — including Bank Holidays. Average response time under 60 minutes anywhere inside the M25.

Water Leak Repair FAQs

How much does water leak repair cost in London?

Leak detection: main water leak detection is a fixed £595. A comprehensive investigation of the whole property, excluding roofs, is £660 and includes tracer gas, moisture mapping and pressure testing. Detection by the hour is £180 per hour with the tracer gas bottle included. It is no find, no fee. Leak jobs scheduled in advance have no call-out fee, and an emergency right-now call-out is £70 with someone there within one hour. Repair work is £95 per hour, and we confirm the price in writing before we start.

How do I know if I have a hidden water leak?

Signs of a hidden leak include: water meter spinning when all taps are off, unexplained damp patches on walls or ceilings, wallpaper bubbling or peeling, musty smell in a room, unusually high Thames Water bills, or soft/discoloured floor sections. We use acoustic listening equipment and thermal imaging cameras to locate leaks without unnecessary damage.

What should I do if I have a water leak right now?

Turn off your water supply immediately at the main stopcock (usually under the kitchen sink or where the supply enters the property). If water is near electrics, turn off the electricity at the consumer unit too. Mop up standing water to prevent floor damage. Then call us — we're available 24/7, and the £60 call-out is waived on jobs over 2 hours.

Will my home insurance cover a water leak repair?

Most home insurance policies cover damage caused by an escape of water (burst pipes, hidden leaks) but not the repair of the pipe itself. They typically cover the cost of tracing and accessing a hidden leak. We provide detailed reports and photographs for insurance claims, and can deal directly with loss adjusters.

Can you repair copper and plastic (MLCP/PEX) pipe leaks?

Yes. We repair all pipe materials used in London homes — copper (15mm, 22mm, 28mm), CPVC, plastic push-fit (Speedfit/John Guest), multilayer composite pipe (MLCP), and older lead pipe sections. We carry replacement fittings, compression joints, and push-fit connectors for same-day repair.

How do you find a hidden pipe leak?

We use a combination of techniques: acoustic listening devices (listen for the sound signature of pressurised water escaping), thermal imaging cameras (wet areas appear as cooler zones), and pressure testing (isolate sections of pipework to confirm the location). This avoids unnecessary wall or floor destruction. Once located, we confirm with the homeowner before any access work.

How can I tell if I have a leak or just a high bill?

Do the meter test. Turn off every tap and appliance, read the meter, wait an hour or two, then read it again. If it has moved, water is escaping. If it has not moved, the bill is more likely down to how much water you use or an estimated reading. Check the cistern first, because a toilet that leaks into the pan also moves the meter.

Is the leak on the water supply, the heating or a drain?

A meter that moves with everything off points to the cold water supply. A sealed heating system that keeps losing pressure points to the heating. A damp patch that appears after a bath, shower or flush points to waste pipework. A pressure test or a drain camera confirms which it is.

How much does it cost to find and repair a hidden leak?

Leak detection: main water leak detection is a fixed £595. A comprehensive investigation of the whole property, excluding roofs, is £660 and includes tracer gas, moisture mapping and pressure testing. Detection by the hour is £180 per hour with the tracer gas bottle included. It is no find, no fee. Leak jobs scheduled in advance have no call-out fee, and an emergency right-now call-out is £70 with someone there within one hour. Repair work is £95 per hour, and we confirm the price in writing before we start.

Do I need to open up the floor or wall to fix a hidden leak?

Usually only a small section, and only after the leak has been located. Once the surveyor has the position, the opening can be kept to the area around the pipe. How much needs to come up depends on the pipe route and what covers it, for example floorboards, screed or plasterboard.

Should I turn the water off while I wait?

If water is actively coming through a ceiling or wall, yes. Turn off the stopcock and, if the water is near lights or sockets, the electricity at the consumer unit. For a slow leak you can leave the supply on if we need it for testing. Do not drain a heating system unless an engineer tells you to.

Leak Guides

Water meter spinning but no visible leak →How much does leak detection cost in the UK? →Water coming through the ceiling from the flat above →Does home insurance cover leak detection, trace and access? →Leak under a floor or slab: signs and next steps →Central heating leak and pressure dropping →

Related Services

Leak Detection →Burst Pipe Repair →Emergency Plumber →Leaking Radiator →Dripping Tap →Boiler Repair →

Got a Leak? Call Now — We're Available 24/7

No find, no fee · Emergency call-out £70, there within 1 hour · Insurance reports · All London

📞 Call 020 7870 3200

Need a Plumber Right Now?

Gas Safe registered. No call-out fee when the job runs over 2 hours. All 33 London boroughs.

📞 Call 020 7870 3200